description

Adhesive (adhesive) pigmented primer with the addition of quartz sand. It is intended for preliminary processing of surfaces of metal embedded parts before applying plaster and cement plasters on them. Resistant to the influence of aggressive atmospheric phenomena, sunlight, alkaline compounds. It can be used as a fastening layer for gluing by means of "tile to tile". Drying time 6 hours.

Concrete-Contact is used to install Heath Plus heating systems under ceramic coatings for adhesive compounds.

After gluing the film on the screed with acrylic glue or mastic and drying the adhesive composition, apply a solution of Concrete-Contact on the entire surface of the film with a margin of 10 cm around the perimeter.

After the primer has dried (6-12 hours), a rough texture of adhered quartz sand is formed on the surface of the film. This texture significantly improves the adhesion of the tile adhesive to the surface of the film.

After the glue and soil have dried completely, you can proceed to install the floor covering.

description

Acrylic adhesive has an increased thermal resistance and is suitable for operating conditions up to + 70 ° C. Thus, this adhesive is suitable for use in heating systems and heat floors Heat Plus for mounting infrared film for tiles, granite, marble or other "heavy" ceramic coatings that are installed on the screed under the adhesive.

When installing the film, it should be noted that the time for adjusting the bands is only 20 minutes, therefore, glue the stripes gradually, approximately 30-40 cm at a time.

After the film has been glued, it is necessary to squeeze the air out of the infrared strips of the film with a plastic spatula. If this is not done, there will be air gaps between the film and the glue, which will affect the quality of the bonding of the screed and the film, and therefore the quality of the installation of the ceramic floor covering.

After the glue dries (from 24 to 48 hours, depending on the temperature in the room) walking on the film is allowed.