Adhesive on acrylic base is used for mounting infrared stripes directly on the prepared screed, for laying the Heath Plus heating system under ceramic coatings on the screed.
It is resistant to high temperatures.
Appearance is a homogeneous paste-like mass of white color.
characteristics
| The rate of consumption | 0,7-1 kg / m2 |
| Packing | 1, 3, 6, 12 кг |
characteristics
| The rate of consumption | 0,7-1 kg / m2 |
| Packing | 1, 3, 6, 12 кг |
description
Acrylic adhesive has an increased thermal resistance and is suitable for operating conditions up to + 70 ° C. Thus, this adhesive is suitable for use in heating systems and heat floors Heat Plus for mounting infrared film for tiles, granite, marble or other "heavy" ceramic coatings that are installed on the screed under the adhesive.
When installing the film, it should be noted that the time for adjusting the bands is only 20 minutes, therefore, glue the stripes gradually, approximately 30-40 cm at a time.
After the film has been glued, it is necessary to squeeze the air out of the infrared strips of the film with a plastic spatula. If this is not done, there will be air gaps between the film and the glue, which will affect the quality of the bonding of the screed and the film, and therefore the quality of the installation of the ceramic floor covering.
After the glue dries (from 24 to 48 hours, depending on the temperature in the room) walking on the film is allowed.
characteristics
| The rate of consumption | 0,7-1 kg / m2 |
| Packing | 1, 3, 6, 12 кг |
| Temperature mode | from -40 to +80℃ |
| Setting time | 24-48 hours |
| Risk class | Безпечний |
composition
Acrylic adhesive.
Application
It is used for gluing infrared film to the screed for installation under ceramic coatings
